Misc/General Technical

4,191 topics in this forum

1. Where To Buy Good Quality Rubber Fuel Hose?!

   By cRaig, July 15, 2017
   • 22 replies
   • 3,547 views
   • 
   • dobboy
   • April 10, 2019

2. Fitting Compomotives with different offsets

   By Donie- C, April 4, 2019
   • 7 replies
   • 1,311 views
   • 
   • jackherer
   • April 6, 2019

3. Nut + Bolt Rebuild, 205 Gti...where To Source Nuts + Bolts?

   By c_robinson, July 1, 2012   

   • obsesseivecompulsive?!
   • 15 replies
   • 3,074 views
   • 
   • MrAndy
   • March 27, 2019

4. Ready to restore my car after 11 years

   By Bally, March 18, 2019
   • 2 replies
   • 1,524 views
   • 
   • cybernck
   • March 26, 2019

5. Bottom engine mount

   By xstian, March 6, 2019
   • 7 replies
   • 1,588 views
   • 
   • welshpug
   • March 15, 2019

6. Tacho

   By woodymi16, March 9, 2019
   • 3 replies
   • 1,102 views
   • 
   • woodymi16
   • March 11, 2019

7. Fuel clip and line routing

   By Telf, March 10, 2019
   • 6 replies
   • 1,151 views
   • 
   • stumpyjag
   • March 11, 2019

8. Fuel breather filter?

   By Telf, March 6, 2019
   • 2 replies
   • 865 views
   • 
   • Telf
   • March 6, 2019

9. CLUTCH CABLE REPLACEMENT

   • 1
   • 2

   By 4ll5op, March 3, 2019
   • 42 replies
   • 7,484 views
   • 
   • 4ll5op
   • March 6, 2019

10. Sunroof sealant

    By Telf, March 6, 2019
    • 0 replies
    • 805 views
    • 
    • Telf
    • March 6, 2019

11. No Reverse Light

    • 1
    • 2

    By Luke, April 11, 2014   

    • Reverse
    • light
    • (and 1 more)

      Tagged with:

      • Reverse
      • light
      • reversing
    • 36 replies
    • 10,439 views
    • 
    • Callum
    • March 5, 2019

12. Help wanted with regards to bonnet cable

    By wellsyuk, March 2, 2019
    • 0 replies
    • 848 views
    • 
    • wellsyuk
    • March 2, 2019

13. 205 xs wiring

    By K20205, February 22, 2019
    • 5 replies
    • 1,654 views
    • 
    • K20205
    • February 23, 2019

14. Locking Wheel Nut Help

    By East_Hud, February 18, 2019
    • 8 replies
    • 1,591 views
    • 
    • Tom Fenton
    • February 22, 2019

15. Rollcage advice

    By jamie_1992, November 18, 2018
    • 22 replies
    • 5,322 views
    • 
    • camgti
    • February 12, 2019

16. Where to source nylon lever bearing - fits in gear selection bar

    By Jakob, January 23, 2019
    • 8 replies
    • 2,566 views
    • 
    • SRDT
    • February 9, 2019

17. Terminal extractor kits

    By Cobalt_drill_bit, October 12, 2018
    • 6 replies
    • 1,764 views
    • 
    • Gavin Waddell
    • January 30, 2019

18. This hose that runs from Induction Hose to somewhere?

    By johnyma22, January 17, 2019
    • 3 replies
    • 1,171 views
    • 
    • MrAndy
    • January 28, 2019

19. Gearbox Mount

    By Simmo, August 2, 2016
    • 23 replies
    • 5,102 views
    • 
    • jackherer
    • January 24, 2019

20. Connector part number

    By Telf, January 23, 2019
    • 3 replies
    • 1,053 views
    • 
    • jackherer
    • January 23, 2019

21. Fuel Line Retaining Clips - Sourcing question.

    By johnyma22, January 12, 2019
    • 4 replies
    • 1,298 views
    • 
    • johnyma22
    • January 16, 2019

22. Object in Fuel Tank

    By rob_mitch, January 7, 2019
    • 0 replies
    • 1,123 views
    • 
    • rob_mitch
    • January 7, 2019

23. Jacking up the rear using the axle?

    By Philpooma, December 30, 2018
    • 2 replies
    • 1,142 views
    • 
    • Philpooma
    • December 30, 2018

24. Blower working on full speed only - Where is the blower resistor?

    By farkash7, December 23, 2018
    • 0 replies
    • 951 views
    • 
    • farkash7
    • December 23, 2018

25. TIG rods for inlets manifolds?

    By Richie-Van-GTi, December 8, 2018
    • 1 reply
    • 1,118 views
    • 
    • petert
    • December 8, 2018