Megasquirt Injector Wiring.

[brianthemagical 1]

basically i'm not sure how to wire my injectors to the ecu. i'm not on about pairing them up. they are 1.9 yellows, about 10 ohms i think. there are two outputs per pair of injectors but on the wiring diagram for MS they are connected at the db37 plug and parraled of the one wire. to me that would make them one 5 ohm (low impedence) injector but i'm not sure how the pairing of the outputs affects this. so, how have you (you being people who run MS at the mo) wired yours? is the diagram perfectly ok? i'd prefere to use my MS for a short while before frying it as i'm not installing the PWM flyback. thanks for any help.

[brianthemagical 1]

can i give this a bump please. just after how existing set-ups are wired. thanks.

[cybernck 400 1 Cars]

well i'm using MS1 but i wired them as per the MS schematic (in pairs) and they work fine .

[brianthemagical 1]

Thanks very much for that, put my mind at rest. Thanks again.