calvinhorse 870 Posted June 2, 2007 im doing a bike carb conversion and my manifold covers the 2 waterways from the head to the origional inlet manifold,... is this ok aslong as they seal?? ive seen a mod where u block the top water hose from going into the manifold to keep the inlet cooler but it never said anything about blocking off the holes in the head?? a very confused calvinhorse.. Share this post Link to post Share on other sites
Sandy 189 Posted June 2, 2007 As long as the holes are sealed. That route is only to simmer the inlet manifold, it's not essential. Share this post Link to post Share on other sites
calvinhorse 870 Posted June 2, 2007 sandy! i knew you would come to the resque!! thanks very much! i owe you a pasty! Share this post Link to post Share on other sites
Sandy 189 Posted June 2, 2007 Haha, I will never forget. Share this post Link to post Share on other sites
