205freak 7 1 Cars Posted September 1 Hi, I would like to know where can I source a 3d drawing of the XU5/7/9 engine, to be able to make a new engine block with the iron liners cast in place as sleeve. Thanks Share this post Link to post Share on other sites
SRDT 171 Posted September 1 That's a lot of work to make something close to the EW engine block. Your best option is probably a 3D scan, this engine was made before CAD so even PSA 3D models are probably good mock-ups but not 1:1 digital replicas. There was no need for that with the tooling already up and running. Share this post Link to post Share on other sites
petert 578 Posted September 3 Pay someone to digitize the one you have. That will be the most accurate and quickest way. 1 Share this post Link to post Share on other sites
Mm xu9 2000 0 Posted September 5 This is a 2000cc carburetor xu9 engine, but I don't know which model it is. Please tell me the full name of the engine, thanks. Share this post Link to post Share on other sites
205freak 7 1 Cars Posted September 5 On 9/3/2024 at 12:47 PM, petert said: Pay someone to digitize the one you have. That will be the most accurate and quickest way. Ok Will do and hope to be able to manufacture it cost wise. Share this post Link to post Share on other sites
205freak 7 1 Cars Posted September 5 6 hours ago, Mm xu9 2000 said: This is a 2000cc carburetor xu9 engine, but I don't know which model it is. Please tell me the full name of the engine, thanks. This might be 1.6 engine or depending on the country could BE a 1.9 but very are. Share this post Link to post Share on other sites
Mm xu9 2000 0 Posted September 9 The engine is 1.9 with Solux carburetor, I can't find the exact model of this engine, which model is xu9, this car is in Iran. Share this post Link to post Share on other sites
SRDT 171 Posted September 9 They are plenty of XU92C : D2A, D2B, D2C, D2D, D2H, D5A. Check the plate on the block. Share this post Link to post Share on other sites
