wladimir031 8 Posted March 6, 2023 (edited) Hi i would like to show my ITB work from start to finish.. enjoy I cut my original GTi inlet manifold Testing angle I made vacum colector for Map and steper motor... to work with oem Ecui instal saab 2.3 turbo injectors (370ccm) Edited March 6, 2023 by wladimir031 1 Share this post Link to post Share on other sites
wladimir031 8 Posted March 6, 2023 First try ... idlee excelent on oem ecu. YouCut_20211212_224109876.mp4 1 Share this post Link to post Share on other sites
wladimir031 8 Posted March 6, 2023 i play with tps sensor because i must use stock gsxr tps .. and then i try again with some trottle. VID_20220510_172452.mp4 Share this post Link to post Share on other sites
wladimir031 8 Posted March 6, 2023 and finaly ROAD TEST.. use headphones hahha sounds great YouCut_20220626_104510688.mp4 1 1 Share this post Link to post Share on other sites
Spesh 28 1 Cars Posted March 7, 2023 Nice Did you get a wideband on it to check the fuelling is ok? Share this post Link to post Share on other sites
wladimir031 8 Posted March 7, 2023 47 minutes ago, Spesh said: Nice Did you get a wideband on it to check the fuelling is ok? nopee .. i only tested ... now i waiting for standalone ecu . Share this post Link to post Share on other sites
Zetec7 4 Posted March 9, 2023 Great work, I used the same T/Bs on my 2-0L Zetec 10 years back & its running on an Emerald ecu closed loop with no problems. 1 Share this post Link to post Share on other sites
mmt 14 Posted January 1 Really nice work. Looks mint. are those injectors a straight fit with the 306 rail and connectors? They look just like the original 306 gti6 ones? Share this post Link to post Share on other sites
wladimir031 8 Posted January 2 15 hours ago, mmt said: Really nice work. Looks mint. are those injectors a straight fit with the 306 rail and connectors? They look just like the original 306 gti6 ones? litle shorter , i cut/shorten and weld rail holder where two 10mm bolt goes .. connectors is the same. Share this post Link to post Share on other sites
mmt 14 Posted January 2 Great thanks mate. do you by any chance have the part number? thanks again. Share this post Link to post Share on other sites
