Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
Equinoxe

Mi-16 Base Base

Recommended Posts

Equinoxe

Hope some1 can support me with a base map for the xu9j4 engine.

Only thing I want is a base map sow I can start it

 

Mods:

KDFI management( same specs as Megasquirt 2xtra)

Fast road cams

dis ignition

Wideband lambde

TPS

IAT

IAC

Running Megatune

 

Ow; wich HT leads are plug and play for the mi head en dis coil?

 

Thx!

Share this post


Link to post
Share on other sites
hexhamstu

are you running ITBS/carbs/original inlet? (sorry not answering your original question but magnecore do custom leads where you pick the ends you want and the length and they make them up for you or you can alse do this yourself i think)

Share this post


Link to post
Share on other sites
wracing

you can make a base map with megatune just enter your engine estimated perameters, if you have a wideband lambda the disable ego correction, go for a gentle drive check datalogs and adjust.

 

ingnition wise you can do it diy but i would really advise you to rr it!

Share this post


Link to post
Share on other sites
Equinoxe

how do I disable the ego correction?

 

I found a base igniotno map here TPS based but what are the nr from 1-15??

Tps load map

Share this post


Link to post
Share on other sites
wracing

under megatune ->basic settings -> exaust gas settings

 

then set the active above rpm to 7000ish

 

i think thats for a megajolt unit, and tbh it looks to consertive, you can get megasquit to generate a spark map just be on the look out for knock1

Share this post


Link to post
Share on other sites
Equinoxe

here again,

engine started en idles ''good''

but when diving it has no power at all!

ve table seems good,no backfires sometimes little hick ups

 

Could this be a timing issue?

search yesterday for a couple of hourse each time after adjustment up and down the road but it really feels dead

Share this post


Link to post
Share on other sites
Guest projectje
here again,

engine started en idles ''good''

but when diving it has no power at all!

ve table seems good,no backfires sometimes little hick ups

 

Could this be a timing issue?

search yesterday for a couple of hourse each time after adjustment up and down the road but it really feels dead

have a look at your acceleration wizard thats were the base of my problem was. also spark makes a lot of difference if u are running throttle bodies. what kinda throttle bodies do u run?

 

but would be helpfull if u gave us your map and a megalog

 

how heavy are ur cams, do u run bigger valves, this is all very important for ur ignition timing

 

regards

Share this post


Link to post
Share on other sites
Thijsjan_Beijer

Looking also for a base map for a Mi-16 on GSXR ITB's with Dis ignition, TPC, wide band....

 

So how did this story end up? :lol:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×