Hardgraf 0 Posted January 2, 2009 Hello I'm in the process of changing my heater matrix. Got the old one out now just trying to fit the new one. Should I attach the matrix pipes to the matrix before re installation or after I've installed the new matrix? Also, does anyone have a picture of a matrix with pipes attached as I can't work out how the seals etc should be used & the bin men have taken the old matrix. cheers Tom Share this post Link to post Share on other sites
jimistdt 1 Posted January 2, 2009 Hello I'm in the process of changing my heater matrix. Got the old one out now just trying to fit the new one. Should I attach the matrix pipes to the matrix before re installation or after I've installed the new matrix? Also, does anyone have a picture of a matrix with pipes attached as I can't work out how the seals etc should be used & the bin men have taken the old matrix. cheers Tom Hello Tom There is a guide in here by PUGTORQUE that may be of some use to you. Share this post Link to post Share on other sites
Hardgraf 0 Posted January 2, 2009 Cheers Jim seen this. I've got the new matrix in, trying to attach the pipes to the new matrix from inside the car. Very frustrating finding it impossibly fiddly. Share this post Link to post Share on other sites
hengti 2 Posted January 2, 2009 from memory, that's the only way you can do it (attaching the pipes after the matrix is home). the o rings go over the lip on the end of each pipe. it's one of those jobs that you need small hands for! at least you didn't start of with Haynes and needlessly remove the dash first.. Share this post Link to post Share on other sites
Hardgraf 0 Posted January 2, 2009 Thanks for that, worked it out now. Unfortunately my hands are too big & my temper is too short. After much swearing I think it might be mobile mechanic time. Share this post Link to post Share on other sites
hengti 2 Posted January 2, 2009 whereabouts are you? Share this post Link to post Share on other sites
Hardgraf 0 Posted January 2, 2009 Horfield mate, bristol Share this post Link to post Share on other sites
hengti 2 Posted January 2, 2009 PM'd - hopefully sort something out Share this post Link to post Share on other sites
Hardgraf 0 Posted January 7, 2009 (edited) Big up to hengti for coming round & helping me out. Forum at its best! Edited January 7, 2009 by Hardgraf Share this post Link to post Share on other sites
