Strange, Inner Bearing Depth Help.

[yorkshirekowboy 19 1 Cars]

hi,

 

as above, just beening measuring old arms, one off a 306, and one off a 309, and measured the distance form the arm to the bearing marks of the old shafts, they measure 21.5cm give or take, but on the guide it states 20cm, but measuring 20cm is the begining of where the shaft goes big to small, dead on 20cm, any ideas? should they been 20cm?

 

thanks

[welshpug 1,626]

have you removed the seal?

 

the bearing is set at 200mm from the end of the tube not the seal.

Edited October 30, 2008 by welshpug

[yorkshirekowboy 19 1 Cars]

have you removed the seal?

 

the bearing is set at 200mm from the end of the tube not the seal.

 

i have mate, im was measuring the old shafts that came out, and the pitted bit where the bearing has worn, form there to the arm reached 21.5cm

[welshpug 1,626]

that'll be where youre going wrong you measure the tube not the shaft.