Guest silverdales Posted October 21, 2008 Hello Mine is a 205 cj convertable, I see in the scrapy a dash with the rev counter etc.... will this just plug in and work or is there connectors not in place for this? Any help greatly appreciated! Steve Share this post Link to post Share on other sites
Jrod 7 Posted October 22, 2008 You will need to run the wiring from the fusebox. Share this post Link to post Share on other sites
Guest silverdales Posted October 22, 2008 You will need to run the wiring from the fusebox. Is this 1 loom from dash back to the fuse board and easy or is it loads of hassle ? Share this post Link to post Share on other sites
Jrod 7 Posted October 23, 2008 (edited) Its easy but alot of hassle at the same time. I had the whole dashboard out when I did it, not sure if you can get away with just taking the bottom half out but if all has to come out then its quite a lot of work. Edited October 23, 2008 by Jrod Share this post Link to post Share on other sites
