oli-pug 6 2 Cars Posted March 14, 2008 (edited) Hi, does anyone know which type of speed sensor a vts box uses? I'm thinking of using this box in my conversion, but i read somewhere i'll need to swap the n/s inboard cv joint? Which ones will fit a 309 gti shaft? Edited March 14, 2008 by oli-pug Share this post Link to post Share on other sites
welshpug 1,630 Posted March 14, 2008 it uses the same speed sensor as the GTi6, i.e purely electrical. not sure what that has to do with the driveshaft though! Share this post Link to post Share on other sites
oli-pug 6 2 Cars Posted March 14, 2008 right cheers, i'll have a look down the scrappy tomorrow for a cable one then Share this post Link to post Share on other sites
welshpug 1,630 Posted March 14, 2008 if you're going gti6 you need the one that drives the cable and has an electrical connection. Share this post Link to post Share on other sites
All Praise The GTI 3 Posted March 14, 2008 yeah as said above need a sensor with both. 306 xsis have them i know that much. i thought my 309 shafts were ok in the vts box till cme home other day and noticed a puddle just swapped inner joint with the vts one luckily i stil had earlier Share this post Link to post Share on other sites
Alastairh 47 Posted March 14, 2008 Check a late ZX DT with a keypad. They also have these sensors on Share this post Link to post Share on other sites
