duncs 0 Posted March 6, 2008 iv a 1.6 shell running a 1.6 beam but iv had a re built 309 beam lying and would like to swap them over what do i need to complete the swap?? Share this post Link to post Share on other sites
welshpug 1,622 Posted March 6, 2008 (edited) tools and handbrake cables possibly some brake pipe fittings IIRC Edited March 6, 2008 by welshpug Share this post Link to post Share on other sites
duncs 0 Posted March 6, 2008 so i can use the 1.6 master cylinder with no problems? Share this post Link to post Share on other sites
John_205_GTi 0 Posted March 6, 2008 I've been told that you can, i'm going through the same process at the minute. Share this post Link to post Share on other sites
Ryan 99 Posted March 6, 2008 I've kept the 1.6 setup (master cylinder, compensator, and pipework) and it's been fine. All you really need for the swap is a pair of 1.9 handbrake cables, and the pipework between the rear calipers and the the rubber hoses round the beam - the 1.6 has hard pipes that go straight into the drums, the 1.9 and 309 have a rubber hose going into the caliper. You might also need to trim off the inner lip on the plastic arch trim if the tyre rubs. Share this post Link to post Share on other sites
