1.6 To 1.9 Swap.

[large 33]

I am putting a 1.9 lump in my 1.6 Gti (instead, not as well ) I was just going to swap the block and head but after reading some posts i think i will also have to change some other bits. Air flow meter,injectors,ecu. Do i have to change these bit or can i use the 1.6 ones and is there any other parts i should change?

[Richie-Van-GTi 70 2 Cars]

if you are using any 1.6 bits use them all, IE ecu with injectors, dizzy and AFM, or all 1.9. You wont get the full benefit if you run 1.6 parts. Much better to swap them over to 1.9.

[large 33]

Spot on, thank you very much.

[pug_ham 240 3 Cars]

http://www.205gtidrivers.com/articles/e1-gti16to19.html

 

Graham.

[large 33]

Thanks for that.It has just given me a small problem, the 1.9 engine i have to go in has the coil mounted above the manifold any handy hints.

[steve@cornwall 100]

Thanks for that.It has just given me a small problem, the 1.9 engine i have to go in has the coil mounted above the manifold any handy hints.

 

Just take the coil off and pretend it was never there! Use the coil set up you already have

[large 33]

will do thanks are the injectors interchangable i.e. dose one plug fit all.

[steve@cornwall 100]

will do thanks are the injectors interchangable i.e. dose one plug fit all.

 

Injector plugs fit onto both type of injector (blue 1.6 and yellow 1.9). As they all fire at once the order is not important either

[zowow 0]

easily done, even though mine took me three months lol

[steve@cornwall 100]

easily done, even though mine took me three months lol

 

My last was a little under 8 hours

[large 33]

Steve you dont want to come and do mine,I will give you £10 for your petrol.