pugbliss 0 Posted July 17, 2007 went to change the top engine mount today but ive rounded off the nut and also sheered the stud/bolt half off too. need help on what to do etc etc Share this post Link to post Share on other sites
Richie-Van-GTi 70 2 Cars Posted July 17, 2007 which part of the mount, the actual rubber? Just tap it round with a hammer and chisel to remove it and slot a new one back in its place. Share this post Link to post Share on other sites
welshpug 1,631 Posted July 17, 2007 make one of these - it makes removing and installing the mounting so much easier Share this post Link to post Share on other sites
pugbliss 0 Posted July 17, 2007 its the top nount nut ive rounded off, so i havent even got to the rubber bit yet? still need help Share this post Link to post Share on other sites
WildCards 0 Posted July 17, 2007 Hammer a slightly smaller socket onto the nut, undo and prise the socket off the nut, it's easier if you have a vice. Share this post Link to post Share on other sites
Jrod 7 Posted July 17, 2007 (edited) Ebay item number: 170131947479 I've never had a nut these can't remove. Even very stubborn locking wheel bolts. Edited July 17, 2007 by Jrod Share this post Link to post Share on other sites
Peetypug 5 Posted July 17, 2007 buy a slightly smaller socket from halfords (it has to be here ) hammer it on and it will come off the reason it has to be halfords is that thier sockets are all under guarantee (a mobile wheel fitter took my old locking nuts off and told me about this) if it breaks take it back and get your money back if not you have a socket to use again Share this post Link to post Share on other sites
pugbliss 0 Posted July 17, 2007 i am right that these bolts can be removed Share this post Link to post Share on other sites
pugbliss 0 Posted July 18, 2007 ive tried everythig now and i just carnt fee it. i carnt even hammer a smaller socket on to it.....its a stuban bastard...... need more help!!!! Share this post Link to post Share on other sites
DaveK 0 Posted July 18, 2007 is it the mount bolt that goes though into the top mount rubber? If so you could always just angle grind or hacksaw it off and replace the mount. You will need to replace the mount anyways if the bolts are knackered?oops didnt read you first post propery, just grind it off Share this post Link to post Share on other sites
Jrod 7 Posted July 18, 2007 Buy the proper kit like I said above ^ Share this post Link to post Share on other sites
