Installed New Rods And Quickshift...

[coombsfh 2]

As above, installed all rods with clips, managed to get quickshift on and all lined up.

That was fine BUT...

I have a BE1 MI16 box and the gear lever has a certain lean backwards to it...not too much of a problem BUT there is still a discernable wobble in the gear stick. Is this because the bracket bolt is not tight?

I looked to tighten the bracket that the quickshift attaches to and it had a round headed bolt(by manufacture no by abuse) and a square nut. It was also made harder to access by the heat shield.

What could be the problem?

Any advice much apreciated

Fred