blue1.9 0 Posted May 18, 2003 As title....what torque do people use for the subframe bolts...the two each side at the rear and the one each side at the front/sides? I couldn't find the specs in Haynes (not sure which section this comes under anyway! Cheers Alex Share this post Link to post Share on other sites
Guest doughboy Posted May 18, 2003 Don't think I torqued mine up... Just use threadlock, then tighten up as much as you can. Share this post Link to post Share on other sites
blue1.9 0 Posted May 19, 2003 Thanks for that....Is this what everyone does? Cheers Alex Share this post Link to post Share on other sites
PHyR 0 Posted May 19, 2003 Yup, I also just did mine up FT with loads of threadlock. Share this post Link to post Share on other sites
blue1.9 0 Posted May 19, 2003 OK - I'll go with that then! Thanks Share this post Link to post Share on other sites
