Jez G 6 1 Cars Posted May 3, 2006 Help !! The above pictures are from the lead going into the distributor from the ingintion module, I have managed to pull the wires out of the black connector. I have no idea which wires go back in which hole ... The black connector is numbered 1, 2 and 3. I have a red wire a green wire and a braded eath. Can someone please tell me the correct wires to put back in the right holes .... Thanks in advance Jez Share this post Link to post Share on other sites
Jez G 6 1 Cars Posted May 4, 2006 Anyone ? I am a bit reluctant to ramdomly try in case I do more damage ! If not I will try to get my local Pug dealer to help ... or sell me a new bit of harness. The car is off the road until I can sort this out. Jez Share this post Link to post Share on other sites
pug_ham 245 3 Cars Posted May 5, 2006 I've got this at home afaik on the loom I removed from my car when I fitted the MP3.1. I'll look later & let you know. Graham. Share this post Link to post Share on other sites
pug_ham 245 3 Cars Posted May 5, 2006 Picture attached, spring clip facing you & they run Black (braided cable), green red left to right. Checked the loom I have & a p;ug that i got from a scrapyard ages ago that I'd forgotten I had. Graham. Share this post Link to post Share on other sites
Jez G 6 1 Cars Posted May 5, 2006 (edited) Graham, thanks, hopefully the thing will start now, once I have sorted this out Jez Edited May 5, 2006 by Jez G Share this post Link to post Share on other sites
Jez G 6 1 Cars Posted May 6, 2006 Worked a treat .... thanks again Graham, it started first turn of the key !!! ... now of for an mot, and no doubt more problems ! Jez Share this post Link to post Share on other sites
