1993 1.9 205 Gentry engine bay electrical connections

[Bremar 7]

YouTube vid link attached. In the process of adjusting my automatic linkage cable I came across a connector which I hadn’t seen before and if anyone knows where it might have gone that would be helpful but also and more worrying  near the  ignition coil there was a burnt out wire that looks to have come from the back of the connector plug for tge coil and was connected to earth. I hadn’t noticed before as it was tucked away and the engine appears to run fine. Any advise re this woukd also be greatly received. 

Thankyou Brett 

 

[Leslie green 163]

Hi Bremar , the little white wire of the coil plug would have had a black female spade on the end and is I believe for noise suppression but generally isn't used and just hangs there , the white connector looks like it might be for the reverse switch for the front of a manual gearbox  gearbox , it may not be used on an auto I don't know for sure.

Edited June 18 by Leslie green

[Bremar 7]

Thank you Leslie. I’m guessing you are right. I’ve done some reseach but found nothing else about the yellow and white wire coming from the coil plug. I’ve attached some photos and I am pretty sure from the length and colour match of the wire it went to the far left red wire which probably explains why it burnt out. Engine still runs fine. I’ve looked at the circuit diagrams in Haynes  (pic attached) but with that wire being burnt out and the cover over the other wires you can’t see any numbers.  I don’t suppose anyone has ever cross referenced colours to these or other numbered wires?? Allways frustrating to not know exactly what’s going on. 
Thanks again everyone. As always this is a brilliant  site

Bremar