Telf 222 2 Cars Posted March 8 I'm just starting my spring clean and noticed the nearside front torsion bar end looking a bit gruppy. I think there was a cap on here when I built it? Anyway cleaned up and picture attached , does this look normal other than the fact it was filled with road grime? It's been 4 years since I built it and just cannot remember! The fluid is just oil where I'm cleaning it out. Paul Share this post Link to post Share on other sites
Telf 222 2 Cars Posted March 8 Ta , I used your guide when I built it. However it doesn't answer my question. Having taken the other wheel off and looked it appears it doesn't have a cover and is infact just dirty and full of road clag. Share this post Link to post Share on other sites
jord294 87 Posted March 8 That's not oe bolt, so previously had work done to axle Share this post Link to post Share on other sites
Telf 222 2 Cars Posted March 8 46 minutes ago, jord294 said: That's not oe bolt, so previously had work done to axle I know I rebuilt it when I built the car... Share this post Link to post Share on other sites
PhilNW 40 Posted March 8 3 hours ago, Telf said: Ta , I used your guide when I built it. However it doesn't answer my question. Having taken the other wheel off and looked it appears it doesn't have a cover and is infact just dirty and full of road clag. I have only seen them packed with grease, cant see any plug on the parts diagram but you could probaly get a grommet or something to fit but not sure how long it would last. 1 Share this post Link to post Share on other sites
Telf 222 2 Cars Posted March 9 Cheers I've cleaned it and packed it with grease. Seems pointless trying to cover it with anything. Share this post Link to post Share on other sites