Youngtimersclassic.com

[1.9er 1]

Have many people on ordered replacement parts from them before for restoration etc?

Am thinking of ordering some stuff from them and am looking for some feedback from fellow enthusiasts who have ordered from them before.

[sp_en_ny 14 1 Cars]

I would be very interested in what peoples opinions are as well, i was considering ordering the CTI rubber window scrapers and don't mind paying such an amount but only if the quality and workmanship is spot on.

[Lukaner 0]

I ordered some stuff from youngtimersclassic. 

It was not alot (front and back bumper fitment kit) and i was not very happy with it.

 

The front mounting kit had the wrong lenghts from the tubes, rear bumper was ok

So i am a little bit disappointed about it.

 

The stuff had a good finish and it was also quite fast delivered.

 

Best regards, Lukas

 

 

[SRDT 146]

If the pictures are accurate then not all parts are high quality.

I wouldn't use their XU9J4 exhaust gasket as long as the OEM style ones from Payen or Reinz are available, on the other hand the one inside their engine gasket kit looks fine.

 

They are not pure Peugeot specialists and you can find most if not all of their stuff elsewhere but it can be convenient to order it all from one place.

[1.9er 1]

16 hours ago, Lukaner said:

I ordered some stuff from youngtimersclassic. 

It was not alot (front and back bumper fitment kit) and i was not very happy with it.

 

The front mounting kit had the wrong lenghts from the tubes, rear bumper was ok

So i am a little bit disappointed about it.

 

The stuff had a good finish and it was also quite fast delivered.

 

Best regards, Lukas

 

 

I am mainly thinking about buying  replacement bumpers and bumper inserts for starters.

[Lukaner 0]

So the kit is not bad but the tubes that are going on the chassis and bumber where about 1cm to long.

If you fittet it like this the bumber will bend out.

 

So i just have taken the rest of this Kit and Sandblasted/ Colored the Original ones.

[Leslie green 80]

Replacement bumpers will never be the same quality as originals as they are plastic  , get used base model ones and cut them down for a gti . The front wing mounting tubes are maybe different between gti and non gti , I'm not sure maybe that is where the problem was Lukaner ? Youngtimers do seem to be remaking a lot of parts which is good as many are obsolete now .

Edited April 27, 2023 by Leslie green

[Lukaner 0]

Everything on my car was original except the front bumber mounting kit. I dont know if the standard 205 has different lenghts of those tubes. The rest of the kit was fine, also the Kit for the rear Bumber. Maybe some wrong measurements in the production, i dont know.