Tu9 bigger cilindersleeve

[Wartjen 0]

I have peugeot 205 tu9 and i like to install the cilindersleeves of a tu24 I know they are shorter but can I make them fit are not

[SRDT 146]

Shorter?

The TU24 is using the same block than the TU1 and TU9 so the Ø75mm liners should fit with no problem.

http://www.miamistu.co.uk/pug/GB/205N/0/01C10A.HTM

 

It's the TU2J2 from the 106 Rallye that is using the taller TU3 block.

[Wartjen 0]

Thanks I thought that tu24 block whas shorter than the tu9 but thanks now I now they will fit I can take the old one out off the engine and look for tu24 lineres

[SRDT 146]

I think the TU24 liners may be borrowed from the 1219cc XZ engine from the 104, Visa and Samba.

[Wartjen 0]

Oke good to know but the tu 9 liner is 122mm and the tu24 is 120mm is that gone be a problem

[SRDT 146]

That's the whole liner right? Check the distance between the seat and the top.

[Wartjen 0]

Yes that's the hole inerliner

[fila1223 1]

https://catalog.mahle-aftermarket.com/eu/streamData?key=local&type=PDF&u=solseit/data/productImg/219123107

according to this XW7 liners should fit and they are for 72 mm piston

But as far as i can see compression height on tu1 pistons is quite a bit lower so it won't be that easy

Edited January 5, 2021 by fila1223