Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Telf

Jobs you put off on the Pug when you know you really should have just cracked on...

Recommended Posts

Telf

My 1.4 GR. Owned it 3 odd years, its always had a slight oil leak.

 

Its an old car I reasoned , they leak, ill look into it one day.

 

3 years later and a oily patch on the drive I decide today to investigate.

 

Its a bloody distributor O ring - that is all, 3 years of oil on the drive for the sake of an O ring!   Anybody else care to share their bone idle tales?

Share this post


Link to post
Share on other sites
205Rallee

My sump gasket leaked for about 11 years, water /oil heat exchanger thing behind the oil filter leaked for maybe 5 years, cooling fan switch not been working for maybe 3 years and about half a dozen other things, all fixed this year without much effort, all put off/ignored but so easily fixed.

Share this post


Link to post
Share on other sites
barneys66

Heater fan squeal.

 

Share this post


Link to post
Share on other sites
Telf
18 hours ago, barneys66 said:

Heater fan squeal.

 

oh yeah that's a prime favourite of mine... lol

 

Share this post


Link to post
Share on other sites
Telf

actually even the classic -my wipers don't appear to wipe away water can take me weeks to actually sort, maybe im just bloody lazy!

 

Share this post


Link to post
Share on other sites
Rob_the_Sparky
On ‎10‎/‎13‎/‎2018 at 3:52 PM, Telf said:

My 1.4 GR. Owned it 3 odd years, its always had a slight oil leak.

 

Its an old car I reasoned , they leak, ill look into it one day.

 

3 years later and a oily patch on the drive I decide today to investigate.

 

Its a bloody distributor O ring - that is all, 3 years of oil on the drive for the sake of an O ring!   Anybody else care to share their bone idle tales?

I've replaced it a couple of times and it seals for a short period then starts leaking again.  Stops the centre of the car rusting :)

Share this post


Link to post
Share on other sites
woodymi16

Definitely my wipers, switched on once for the MOT and then last week on a track day. Completely useless at the moment! 

Share this post


Link to post
Share on other sites
ian010778

Yellow cap on rear number plate fixing - drove around with a rusty screw head on show for nearly 6 months!

 

Swapped it three weeks ago and it still makes me smile every time I use that car.

Share this post


Link to post
Share on other sites
pp205

Minor rust treatment and rust prevention - coming back to bite me now

Share this post


Link to post
Share on other sites
Bobbafett

Literally everything. Been up on axle stands for a year now after failing the MOT on some minor stuff. Currently looks like this though but it's taken a year:

 

 

IMG_7509.thumb.JPG.f91c8f46055473687ce08a2a4e9dd12f.JPG

 

  • Like 2

Share this post


Link to post
Share on other sites
Telf

My GR really has a long list

1.door that doesn't always close properly

2. Mysterious squeak in door detailed above.

3.rear wash wipe failed.partailly investigated but not resolved.

4.oil drip. O ring changed . Drip still present.

5. Sloppy gear change. Works but meh! Definitely the rods.

6. Glove box. Zip tied as the lock has failed.

7. Windows all. Various grubby stickers that I really should remove!

8. Alloys . Need a fresh coat of paint

9.fit a new rear wiper blade but see point 3.. 

10.fit new pedal rubbers because they are knackered

11. Fit new bulbs in the dash so i can read stuff at night.

12. Fix the squeaky fan... Again

13. Investigate the odd smell when I turn the heater on. Smells like coolant but goes away after 30 seconds. But coolant level stable .

14. Refit my door card pockets 

15. Change the air filter 3 years and counting

Etc lol

Edited by Telf

Share this post


Link to post
Share on other sites
Telf

I have however (for the sake of balance) recently changed the top mounts, fitted new leads,ignition coil and sparks,fitted a new ignition amp. Fitted a new set of tyres and brakes pads and discs. Serviced it(apart from the air filter)

Share this post


Link to post
Share on other sites
jackherer
1 hour ago, Telf said:

5. Sloppy gear change. Works but meh! Definitely the rods.

You say that but when you get around to fixing it all you'll find is a loose bolt on the subframe that takes 30 seconds to tighten. Very much in the spirit of this thread ;)

  • Haha 1

Share this post


Link to post
Share on other sites
Telf

I've thought of another! 

 

This time the GTI. Plagued by this for years and yet I know how to fix it.....

 

Drum roll...

 

Sometimes I turn the key

 

And the starter just_____________?!!

 

Answers below?

 

Share this post


Link to post
Share on other sites
steve@cornwall

The sometimes hard to unlock passenger door.

Finally had to remove the handle and lubricate when it refused point blank to unlock last week. now smooth as anything, but.....

I really should have lubricated the window sliders whilst it was stripped down as window is very slow to operate.

Sluggish wipers, put up with for years until it stripped the plastic gears in the motor.

Oh, also the creaky passenger door that i ignored until the roll pin rusted enough for the bottom hinge to separate.

CLEAN IT!!!! 

Respray, the roof is now " cherry white" (six months after cherry pink! ) 

 

As for the cti......finish the bloody 16v conversion,,, or sell it to someone who will

Share this post


Link to post
Share on other sites
Ozymandis

Hmm, was in Sainsbury`s  t`other day , had to manouvere a bit to reach the car park ticket machine through the open door.

6 months ago the spot welds on the pressed steel channels affixed to the bottom of the drivers window, seperated and disconnected the glass lifter at the front and I havent been able to open the window since.

Need to strip the door and sort it soon, as it`s a real pain using the car now.

Share this post


Link to post
Share on other sites
Tom Fenton

I may be wrong but I think you will likely find that the bottom lifter on the glass is totally rotten and fallen to bits. I've seen it a number of times now. I would say make sure you've a better one to hand before you start the job!

Share this post


Link to post
Share on other sites
Ozymandis

Normally thats what I expect Tom, but this time, the usually rotten bit is fine but has broken across the spot welds. I had a look inside and the bottom bit was sat in the base of the door.

It was on the glass when the door was forced open by scum and they stressed it badly, amazingly the glass didnt break.

 

Share this post


Link to post
Share on other sites
gazzer

building my mi16 dimma thats been in garage since 2002 lol.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×