Loom Connector Id Please

[soundguy 13]

Hi, can anyone ID any of these loom connectors please?

Do the yellow multis need to connect to the each other, because I've binned the junction that I think they were attached to - ie, the same junction that's inside the rear bodywork area where the passenger light cluster mounts.

[farmer 327 1 Cars]

Left one looks like the headlight bulb connector

[soundguy 13]

Thanks - but the pics are stacked for me, black or white?

[farmer 327 1 Cars]

Black connector.

[soundguy 13]

Thanks, trying to upload from a phone, will have to do this from a puter. Does the black connect to the back of the bulb mount with the spring clip?

[farmer 327 1 Cars]

Straight plug into the headlight bulb yes

[Anthony 1,000]

Hi, can anyone ID any of these loom connectors please?

Black one is the main H4 headlight bulb, so yes, the one with the spring clip.

 

The white one looks like it's the one for the ABS, assuming that it's a Ph2 car and located near the expansion tank. If so it's typically disconnected (unless you have the optional ABS fitted, of course).

 

Do the yellow multis need to connect to the each other, because I've binned the junction that I think they were attached to - ie, the same junction that's inside the rear bodywork area where the passenger light cluster mounts.

The yellow multiplugs you mention sound like earth plugs - if so, you need to have them attached to the earth point (the bit it sounds like you binned!)

[toolie72 67 1 Cars]

Yellow plugs-my spotlights have yellow plugs behind headlights

[welshpug 1,626]

yep, the earth uses a 5 pin male plug (female contacts)

 

Driving lamps use a female 2 pin yellow plug housing with male contacts.

[soundguy 13]

Thanks for the IDs and additional info, really helpful - this loom's been driving me nuts! Got a few more pics if you wouldn't mind (had to use imgur, having problems with the built in uploader:

 

http://imgur.com/ejha6aB

http://imgur.com/5VrhZVf

http://imgur.com/NnNSmnQ

http://imgur.com/xLa4GYm

Edited December 6, 2016 by soundguy

[welshpug 1,626]

not sure on the two black plugs, location doesnt ring a bell but the SAD and Injectors both use 2 pin plack plugs.

 

yellow connector pictured is an earth.

 

3 pin blue and all connected to it is the cooling fan.

[soundguy 13]

Thanks Mei, very helpful as always! The injectors are all connected, SAD isn't so that's one I can hook up.

 

The brown plug near the gearbox, am I right in thinking that's the sensor loom for the three on the back of the block near the distributor, and two on the front under the intake next to the oil filter?

[welshpug 1,626]

yes, and the oil temp on the rear of the sump, and the starter solenoid if its a mid age vehicle, earlier cars had less wires in the plug though.

[soundguy 13]

Great! Should be able to make some good progress - thanks.