2052006 10 Posted June 18, 2015 This buzzer sounds sometimes, albeit at a very low volume, when I have the blower motor on full. It also started sounding when using the indicators at one point. It seems to be linked to when there is a high electrical load. Can anyone explain?! Share this post Link to post Share on other sites
jackherer 543 Posted June 18, 2015 It'll be caused by a bad earth somewhere probably, check the ones related to the things that make it happen. Share this post Link to post Share on other sites
2052006 10 Posted June 20, 2015 Ok thanks, wondered if it would be the earths, will check. Digressing slightly, but said blower motor is rather slow to come "on". Nothing happens for a few minutes, despite the dial being turned to "high", and then it decides to stop being on strike and gets going. Once it gets up to speed, it's not too bad. Is this likely to be the blower motor itself, the transitor (the thing near the motor, which often gives problems I think?) or the dial/circuit board? Thanks. Share this post Link to post Share on other sites
welshpug 1,737 Posted June 20, 2015 Definitely the motor, it runs full current on the highesr setting. Share this post Link to post Share on other sites
2052006 10 Posted June 20, 2015 Can these motors still be bought new? Thought they were relatively cheap from the likes of GSF, but can't seem to find them online. Anyone bought one recently? Share this post Link to post Share on other sites
