burr_2000 1 Posted May 15, 2015 (edited) folks need your help, i am wiring my track car with a rebel wire kit. i am wanting to use the original ignition switch, dont want to go down push button route for safety. the kit has 5 wires going to the ignition switch. IGN SW POWER IGN SW ACC IGN SW IGN IGN SW START COIL The barrel has 4 wires leading into it. orange red yellow yellow (with green dash) these lead to two multi plugs where i can get wire numbers on the opposing side. orange - 46 (starter) red - 1 and 1 c (unswiched feed) yellow (green dash) - 33 A and 33 (accessories) yellow - 32 A (Switched feed) for the coil i will use my DTA. i take it IGN SW START is orange and IGN SW ACC is yellow (green) but not sure about the feeds, i could trial it later but want to be 100%. any help appreciated. cheers, Neil Edited May 15, 2015 by burr_2000 Share this post Link to post Share on other sites
burr_2000 1 Posted May 15, 2015 red to switch power orange to switch start yellow (green) to accessory yellow feed to switch ignition Share this post Link to post Share on other sites