Vacum Leak

[daneldridge23 15]

Hi guys

After doing some research in to the problems im having, I have come to the decision I have a vacuum leak somewhere on my engine

Problems being things such as not idling, idle control screws not changing the kg/ph, fuel ajustments on the ecu not making any sense (omex technicians help)

 

what I would like to know is the best way to find these leaks and where to start looking!

Thanks

[cheesegrater 43 1 Cars]

Spray some brake cleaner around the inlet system gaskets, pipes etc. If it picks up then your leak is nearby.

[welshpug 1,626]

what is it?

[daneldridge23 15]

its an mi, found the leek, its on the no 3 cylinder, also my air temp sensor is shot! was showing 150 degrees!!

 

does anyone know if i can still get hold of a ptfe gasket for this, also is there anyone making angled plates for the inlet manifold as it is never going to fit under my bonnet as it is sitting

[welshpug 1,626]

get a proper maniflod

 

satchell engineering can sort you one that does fit

[daneldridge23 15]

got any contact numbers?

[welshpug 1,626]

facebook.com/SatchellEngineering Edited October 11, 2013 by welshpug

[daneldridge23 15]

how much do they usualy go for and are they a good purchase

 

cash is a bit tight!

[welshpug 1,626]

I believe it was £180 if you supply a donor o.e manifold.

 

you can sell your old jenvey one on quite easily.

 

 

make more torque and power, and fit easier

[daneldridge23 15]

i haven't got my oe one sold it on ebay!

 

probably look better to!