dave205 19 Posted November 23, 2012 Whats the best paint to use? And obviously a serious clean/ degrease before hand! Share this post Link to post Share on other sites
dantheman 0 Posted November 23, 2012 Hi Dave, I have just cleaned an engine block with gunk and then a little carb cleaner. I have used VHT paint before that I got from Mill Auto but the colour was totally different to the indication on the can! It was supposed to be red but ended up orange! I painted the block with black high temperature gloss from Halfords, it needed two coats but came up nice. Share this post Link to post Share on other sites
dave205 19 Posted November 23, 2012 Im going to be after some red for mine and ive got jizer to degrease it. How much of your block did you do? Share this post Link to post Share on other sites
Cameron 16 Posted November 23, 2012 (edited) Pleeeeeeease don't paint it red! It will look awful as soon as it gets any oil / fuel / coolant spillage and / or starts to flake off! Edit: I did not paint this engine! It was removed from my car and thrown away! Edited November 23, 2012 by Cameron 1 Share this post Link to post Share on other sites
Mad Scientist 106 Posted November 23, 2012 Lol. Nice job! Don't paint alloy blocks. It won't last. Best stuff for iron blocks is engine enamel, funnily enough. They sell it in halfrauds. Only black is acceptable! Share this post Link to post Share on other sites
Cameron 16 Posted November 23, 2012 The only colour I would paint an alloy block is silver, and to be honest that's only if I couldn't get access to a blaster and / or steam cleaner. I did mine silver and it looked brilliant for a little while, but after few part swaps and dismantling sessions it got filthy and started to flake; if it was any other colour it would have looked terrible. Share this post Link to post Share on other sites
dave205 19 Posted November 24, 2012 Point taken cameron that looks shi*e in red now its flaked. I really dont wont black, i think silver could look good? Its an iron block anyway not alloy one. Share this post Link to post Share on other sites
Mad Scientist 106 Posted November 24, 2012 It will be fine if it's an iron block. You can use hammerite too, which lasts well. It's all in the prep. Plenty of wire brushing and a good dose of thinners before painting. Share this post Link to post Share on other sites
Cameron 16 Posted November 24, 2012 Yeah make sure you get every last bit of oil and sludge off it and it should last a bit better! I still think you shouldn't paint it red though. Share this post Link to post Share on other sites
dave205 19 Posted November 25, 2012 Nah im going to go with silver i think! Share this post Link to post Share on other sites
Chris H 10 Posted November 25, 2012 Hycote do a really good engine enamel spray paint in "aluminium" colour. Used this quite a few times and had very good results so far Share this post Link to post Share on other sites