CaptainP 2 Posted February 27, 2012 So now that I have my nice shiney new VAC advance unit on my distributor and fitted to the car I thought I'd take alook at my spare unit. I noticed that the signal cable was in a pretty poor state the other day but I didn't realise how bad, the red wire was hanging on by a single strand of wire. I have managed to remove the 2 small lucar connectors from the plug at the dizzy end and will resolder or crimp the 2 wires. I can see that there is a braided section to the wire and at the ignition amplifier end the yellow plug has 3 connectors inside (which is in good condition). Should the braid wire be connecting to anything? Share this post Link to post Share on other sites
welshpug 1,737 Posted February 27, 2012 I don't think its connected at the dizzy end, that cable is the predecessor to the crank sensor and does much the same job Share this post Link to post Share on other sites
cRaig 281 1 Cars Posted February 27, 2012 I think it acts as a shield wire, so therefore isnt connected to anything at the dizzy end? I may be wrong, but I didnt some research into that cable when I was looking to replace mine last month Craig Share this post Link to post Share on other sites
CaptainP 2 Posted February 27, 2012 Ideal thanks chaps. It doesn't look like it should be connected anywhere to be fair. Thanks Steve Share this post Link to post Share on other sites