locosaki 0 Posted September 2, 2011 In the process of putting my track car back to standard interior etc. Now I'm needing to reconncect the heater as the dial were butchered for gauges ! I have got the electrical plug for the control mechanism at the dials it was just disconnected, Now down by the fan unit there is 2 thick wires that run back towards the rheostat, These were bridged out so the heater would work. On the multi plug that goes to the rheostat I have another load of wires that appear to have been snipped, Are these likely to be part of the heater controls ? If it help I can go take a picture, I would like the car to be working as it should, Before the heater worked with a simple toggle switch. Share this post Link to post Share on other sites
