Carbs4me 45 Posted February 11, 2011 Hello, Ive just put my engine in the car, which was a replacement engine, the dizzy (which is a screw on) on the new engine is male ended and the coil is a female ended. The lead that runs from the dizzy to the coil is also a female ended both sides? it wont plug into the coil But on my other engine my Dizzy was also a female which is a clip on?.. i dont know what to do with it? any suggestions? is there a male ended coil? Share this post Link to post Share on other sites
Anthony 1,003 Posted February 11, 2011 There's basically two coils on a 205 GTi - wing mounted on pre-90 cars (female) and inlet mounted on 90-onwards cars (male) Dizzy caps there's two main types as well - pre-90 1.6 GTi's that use a female clip-on cap, and 90-onwards 1.6 and all 1.9 (non-CAT) that use a male screw-on cap. So depending which combination you have, depends which HT leads you need: Wing-mounted coil and female cap = pre-90 1.6 GTi Wing-mounted coil and male cap = pre-90 1.9 GTi Inlet mounted coil and male cap = 90-onwards 1.6 and 1.9 GTi. Often the HT lead sets for 1.9 GTi's include two kingleads, one for wing-mount and one for inlet-mounted coils, but not always so best specifying. Share this post Link to post Share on other sites
Carbs4me 45 Posted February 11, 2011 (edited) would it be posible to use the old lead, and the lead that fits the dizzy on the new engine. if i pull the ends off and clamp the wire back inside the plug housing on the on lead that currently fits my dizzy. sounds abit confusing after i read it back to myself... but im sure you will get what i mean So sort of make a bodge lead from 2 that will fit? Just as a temp fix to actually see if this engine runs... ive not heard it yet just got a gurantee with it. Edited February 11, 2011 by Carbs4me Share this post Link to post Share on other sites