ORB 227 1 Cars Posted October 17, 2010 Hi folks, as much as I love my 1.9, I love 16v power too! I have been offered a Xsara VTS 1998 on an S reg for not bad money. I have done a couple of MI16 swaps and I find them quite simple. But I have never done a GTI-6 swap. What exactly is involved other than whipping the engine out and sticking in the new one? Do I need to alter radiator position? Do I need to do anything daft with the loom/ECU? What other wiring is involved? I am not 100% that I am gonna go ahead and do this, but I a, going to see how cheap I can get the car tomorrow before I make a decision. Obviously I am aware of the other bits that I can utilise from the car, but what box would you use? The 5 speed from the Xsara or my current 1.9? Share this post Link to post Share on other sites
blessed6383 0 Posted October 17, 2010 not done one of these yet myself but had a few mi16, have a feeling the exhaust manifold needs some work and that you will need the ecu kept unlocked but dont think theres major work/cost involved if you haveboth cars. also look in to the thermostat adaptor plate as know this needs to be changed Share this post Link to post Share on other sites
boldy205 75 Posted October 17, 2010 BBM make a stat adapter to use a 8V stat take off., and someone, pretty sure it was QEP, made a exhaust manifold angle plate to use a GTI6 exhaust manifold. Apart from that its quite straight forward, but i dont know much about the wiring as i used carbs and megajolt. Matt Share this post Link to post Share on other sites
Daviewonder 533 3 Cars Posted October 17, 2010 Miles does the modified exhaust manifolds Share this post Link to post Share on other sites
harryskid 193 Posted October 18, 2010 BBM engine mounts, Miles ex manifold and loads of luck! Share this post Link to post Share on other sites
boombang 2 Posted October 18, 2010 Do QEP still exist? Share this post Link to post Share on other sites