1.6 Abs Driveshafts?

[cheesegrater 43 1 Cars]

Hi, I need a new right hand driveshaft but my GTI has ABS, do I need a ABS driveshaft or is the ABS wheel part of the hub? Reason I ask is I can not find any ABS driveshafts and I don't want to buy the wrong one.

Cheers,

Tom.

[Paul_13 212 1 Cars]

ABS is part of the shaft, there's notches that go around the outer CV.

 

There's a sensor in hub aswell.

[cheesegrater 43 1 Cars]

ABS is part of the shaft, there's notches that go around the outer CV.

 

There's a sensor in hub aswell.

Lame, do you know of anywhere where I can get hold of one? Euros can only get hold of non ABS shafts. I'll have to cancel my order then

Edited April 29, 2010 by cheesegrater

[Paul_13 212 1 Cars]

Ah...

 

Wanted post? Or do you want brand new?

 

I think a 1.9 ABS setup is obtainable from GSF in Whitley Reading. Mind you they are fecking useless.

I think the 1.9 ABS driveshafts woud be easier to get hold of but it's trying to get the hubs....

 

Ditch the ABS?

 

Out of interest did it work? Mine never did.

[Ryan 99]

I'm pretty sure 1.6 ABS models have the same hubs and driveshafts as the 1.9 ABS

[mhyphenl 10 1 Cars]

I'm pretty sure 1.6 ABS models have the same hubs and driveshafts as the 1.9 ABS

 

Yes, think so!

[cheesegrater 43 1 Cars]

Yes, think so!

So any GTI 205 ABS driveshaft should fit?

[mikeyd 13]

the 1.6 and 1.9 abs wheel bearings are same so must be the same outer cv

[Paul_13 212 1 Cars]

Come to think of it, the ABS hub on my 205 was a 1.9 hub. even though it's a 1.6 gti.

 

Never crossed my mind

Edited April 29, 2010 by Paul_13

[welshpug 1,621]

if its the outer CV you can replace them on their own, most motorfactors can supply them, around the £35 mark.

[Paul_13 212 1 Cars]

How the heck do you get them off Mei?

I remember giving it a go years ago but it didn't end well. Just had a big boo boo

[cheesegrater 43 1 Cars]

if its the outer CV you can replace them on their own, most motorfactors can supply them, around the £35 mark.

It's the inner one unfortunetly, the one that goes to the engine mounted shaft.

[welshpug 1,621]

swift tap with a copper hammer, job done

 

a big DOH if its the inner one though, although it is identical to the non-abs 1.9 shaft in that respect, as well as nearly any other XU engine (some 1.6's have a TU type inner joint with a metal sleeve) you could get a second hand 1.9 shaft an swap the tripod and inner shaft as far as I know.