hexhamstu 9 Posted January 29, 2010 It's on, what's broken? The ABS is definitely not working. It came on after the car had been sat for awhile. Not really sure how the ABS system works. Any pointers? I don't have a haynes manual for it if someone does could they have a quick peek and see if it has any hints? Cheers Share this post Link to post Share on other sites
SurGie 54 Posted January 29, 2010 ABS sensor's near the hub bearings ? Share this post Link to post Share on other sites
welshpug 1,737 Posted January 29, 2010 check this stoo http://www.306gti6.com/forum/showthread.ph...7555&page=1 Share this post Link to post Share on other sites
hexhamstu 9 Posted January 30, 2010 Didnt realise it was an MOT fail, cheers mei! Share this post Link to post Share on other sites
jorg 11 Posted January 31, 2010 I have just had the ABS sorted on my 306 HDi. The ABS ring on the n/s driveshaft snapped so I had it replaced, but the ABS still wasn't working. It wasn't til I took it to Woodsy on here that we found the problem. Turned out when the ring snapped it bent the pin on the ABS sensor at the same time. So after a sensor placement and a system reset its all good once again. Share this post Link to post Share on other sites
hexhamstu 9 Posted August 3, 2010 Finally got round to sorting this, front left had the correct resistance but didnt switch between 0 and 1 volts. So tried to remove the sensor and it snapped off in the hub. MINT! Share this post Link to post Share on other sites
welshpug 1,737 Posted August 3, 2010 as they do, always! at least it was buggered anyway! Share this post Link to post Share on other sites
hexhamstu 9 Posted August 3, 2010 Any tips on getting all the s*it out? I've got most of it out by gauging with a screw driver. Share this post Link to post Share on other sites
hexhamstu 9 Posted August 4, 2010 The ring is also snapped, eurocarparts and GSF don't stock them, waiting for a call back from the stealers. Share this post Link to post Share on other sites
woodsy 0 Posted August 4, 2010 You maybe better trying to price a cv joint as iam sure you cant by the rings seperately for 306.I could be wrong though. Share this post Link to post Share on other sites
welshpug 1,737 Posted August 4, 2010 what woodsy said, I've only heard of Renault selling the rings separately, sounds like it was a cheap Driveshaft anyway as the rings on o.e shafts are machined out of the CV rather than a pressed on ring. a Joint would be about £35. Share this post Link to post Share on other sites
hexhamstu 9 Posted August 4, 2010 I've ordered a new drive shaft at GSF you can buy the rings seperately off the internet for about £15 + postage. But the end of the driveshaft is all corroded so the ring won't seat properly even if I buy a new one. So I've bit the bullet and splashed out £67 for a new shaft. I thought that was a pretty good price TBH, I made sure it was an ABS one aswell. Share this post Link to post Share on other sites
