Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Bogsye

[engine_work] 1.9 8v Engine & Front End Refresh

Recommended Posts

pug_ham
10 hours ago, ladderboy said:

I'm also starting on a repair job for badly rusted rear of boot floor. These, "Boot repair panels which replace rear 250-300mm of floor", where do you get them from? Brian in Glasgow, did you get a floor CAD drawn and laser cut, and if so, could I get one?? Or were you referring to the subframe? Thanx!

 

 

I don't know where Brian got his panel from but they are available from Expressed steel panels.

 

g

Share this post


Link to post
Share on other sites
Bogsye

Sorry for the slow response!

 

Yes, my repair panel for the bootfloor cam from Expressed Steel Panels as linked above by Graham.

The bit I need to get fabricated is the crossmember that sits underneath the floor and runs across the width. I've taken it off but need to get it drawn up and then laser cut and folded. Life has got in the way recently but hopefully I'll be back on this again soonish..

 

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×