hcmini1989 16 Posted October 10, 2009 right ive bought a seconhand roll cage .i was wondering how thick do the mounting plates need to be do i weld the plates to the car then bolt through them .do i put the plates inside and outside the car sandwiching the floor between them .thanks for any help Share this post Link to post Share on other sites
welshpug 1,627 Posted October 10, 2009 3mm is ideal, you'd normally fit them inside, most are a box type but some are plates, depends which cage it is. Share this post Link to post Share on other sites
hcmini1989 16 Posted October 10, 2009 3mm is ideal, you'd normally fit them inside, most are a box type but some are plates, depends which cage it is. its a safety devices one 4 point but i cant find any pics of it any were.otherwise id stick some up and im going to be making the mounting plates .3mm it is then thanks Share this post Link to post Share on other sites
hcmini1989 16 Posted October 10, 2009 4 point?! well i think thats what you call it it onlt has 4 mounting points .its just the rear part of the cage.so only goes in the back but has brackets to fasten the front parts to Share this post Link to post Share on other sites
