Jump to content
  • Welcome to 205GTIDrivers.com!

    Hello dear visitor! Feel free to browse but we invite you to register completely free of charge in order to enjoy the full functionality of the website.

Sign in to follow this  
Alan_M

Spraying Advice

Recommended Posts

Alan_M

I'm currently getting welding work done on my 205 to lower my drivers seat down, by doing the cutting out of the exhaust tunnel method. Hopefully the work should be done by this weekend and I therefore need to protect the new metal.

 

When welding in the reinforcement plates/mounts on the sill, the underseal got burnt off too.

 

What should I spray it with, the interior sections and underneath.

 

I was going with a good clean up on the inside then a couple of coats of red oxide paint, then Hammerite it.

Share this post


Link to post
Share on other sites
gti-si

I'd etch primer the inetrior or get some high zinc primer, then paint with your hammerite over the top, should keep the rust at bay. Use some Schutz type underseal underneath

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×