Rob Turbo 3 Posted March 28, 2009 I want to put 1.9 hubs on my 205 so I can fit decent brakes when the turbo lump goes in, I have a pair of 1.9 hubs/carriers but the balljoint hole on both of them is oval, can I just press the hub out of the bearings and press them into new bearings on the 1.6 carriers? Or are the carriers different as well? I've had a look on service box but it isn't that clear. Thanks, Rob Share this post Link to post Share on other sites
BackStreetRacecars 3 Posted March 28, 2009 Yes they are the same iirc.... I vaguely remember using 1.6 ones with 2.9 drive flanges annd 1.9 beatings for rebuilding my graphite 205!!! Share this post Link to post Share on other sites
jplautomotive 0 Posted March 28, 2009 (edited) no there not , the 1.9 uses a bigger bearing . i thought they where till i tryed to fit 1.9 bearings and flanges to mine , they dont fit i.6 hubs edit service box list different for xu9ja (1.9) Edited March 28, 2009 by jplautomotive Share this post Link to post Share on other sites
BackStreetRacecars 3 Posted March 28, 2009 (edited) Yes they are the same iirc.... I vaguely remember using 1.6 ones with 2.9 drive flanges annd 1.9 beatings for rebuilding my graphite 205!!! excuse the terrible spelling... was typing fast... but does say it all there!!! 1.9 drive flanges and 1.9 bearings.... EDIT: just read what jplauto said..... sorry!! I'm positive I've done this before and it worked!!! Edited March 28, 2009 by BackStreetRacecars Share this post Link to post Share on other sites
Baz 421 Posted March 29, 2009 different offset too. Share this post Link to post Share on other sites