omega 82 Posted March 7, 2009 (edited) got a new ignition lock to fit removed the bolt and got the key in postion" a "as stated in the haynes,then it says push in plunger to remove as shown in photo but theres no photo!!so where is the plunger as i cant see it Edited March 7, 2009 by omega Share this post Link to post Share on other sites
welshpug 1,626 Posted March 7, 2009 its a small pin on the side of the barrel, press it and turn the key till it will go in, then pull it out with the key. Share this post Link to post Share on other sites
omega 82 Posted March 7, 2009 its a small pin on the side of the barrel, press it and turn the key till it will go in, then pull it out with the key. thanks mate the secret is to turn the key [not in the haynes book]then it comes out Share this post Link to post Share on other sites
Goliath 94 Posted March 7, 2009 There is a small arrow or mark between positions A and B (I think its A-, the key needs to be lined up with that and then the positioning lug will press down and you can remove the whole barrel. Share this post Link to post Share on other sites
Phil H 16 Posted March 8, 2009 ...and don't forget to take out the grub screw on top !!! Share this post Link to post Share on other sites