The Release Bearing Arm On Be1

[Guest PugHalvor]

Hello.

Does anyone have a picture of the release bearing arm(fork?) on the be1 gearbox ?

Not the L-shaped part that is connected to the wire, but the part that goes down in the bellhousing.

I really need an IRL picture of this, to se if mine is broke.

[pug_ham 242 3 Cars]

There might be a suitable picture in this topic

 

Graham.

[DamirGTI 327]

Ok this is an early 1.6 BE1 gearbox :

 

 

 

.. there's little plastic bush which holds the fork attached on the box casting pin , this one :

 

 

.. didn't replace this part yet but here is how it looks like on the fork/box casting side :

 

 

 

Damir

[Guest PugHalvor]

Ah. Thank you guys

But is the bearing supposed to sit all tight around the shaft, or should it be a little slack in it ?

[pug_ham 242 3 Cars]

IIRC the bearing just hooks over the arm but not particularly a tight fit.

 

Graham.